|
|
|
Engines
|
|
Re: Harmonic Balancer Install, Can I Do It This Way?
by
70Nova
9 minutes 23 seconds ago
Heat the balancer around the center hole to make the hole bigger, you get an easier fit that way. Use a handheld propane torch or something but don't heat too much or you may compromise the bond of the rubber membrane in between the hub and the pull
|
|
|
Swap Meet
|
|
|
Re: GMC Engine Parts for Sale, Fallbrook, Ca 5/26
by
radar
Today at 08:58 PM
Hi Andy,
Sorry it took so long to answer. The oil pan was up high in the rafters of my garage in a box and I needed help in getting it down. Your question is a good one. I think I have a military version of the oil pan . It has a larger ca
|
|
|
Engines
|
|
|
Harmonic Balancer Install, Can I Do It This Way?
by
chevymike
Today at 08:52 PM
Hi all again,
Getting closer to getting the 250 back together. I have read everywhere that I should drill and tap the crank but I am not sure I want to risk it and screw something up.
I know using a mallet is not great on the t
|
|
|
Engines
|
|
|
Shave the 230 head .060" still safe?
by
70Nova
Today at 08:34 PM
I've been crunching my numbers and weighing my options here for a while, and this is pretty much what I'm looking at. I need to mill the head .060" to get 9:1 compression ratio that I want. (For my mild cam). Question is, is it safe to shave th
|
|
|
Engines
|
|
|
Re: Chevy 230 build intake/exhaust questions
by
Joey
Today at 04:23 PM
Worked through re-jetting the 32/36 carb for actual performance. Had a huge flat spot in the power-band at 35-45 mph. I set up the primaries at 140 and 150 secondary. Still have a slight bog if I floor it at 35-45 mph. Talking with Tom, I am first go
|
|
|
Swap Meet
|
|
|
1973-80 Chevy 250/292 Vintage Air system for sale
by
sodell
Today at 08:44 AM
I have a complete Vintage Air SureFit system, part # 944175, for sale a lot cheaper than you can buy it new. Everything still in the box and brand new. Got hurt bad and can no longer use both arms well so the heavy work has to go. Also have a new 292
|
|
|
Blown and Injected
|
|
|
Re: A little more progress on my intake manifold
by
Beater of the Pack
Today at 08:19 AM
It may be moving slowly but what gets done is done well. Life and $$ keeps getting in the way of my roadster project. I have almost everything but can't seem to get a few key things done so I can move forward. Keep at it, That is going to be a great
|
|
|
|
|