Intake Manifold Mount Modification - 03/30/22 09:18 PM
A couple of years ago I built a Multiport Fuel Injected 292. Tom Lowe built the long block for me. Most of the EFI components were either a modified off the shelf item, or were completely custom. One of the ideas that was developed during that build was a modification to the intake manifolds that would allow you to install the manifold OVER the top of the header flange. You would use threaded studs and flanged nuts instead of the old clip that GM used to span both the intake and exhaust simultaneously. With this design you install the header and torque it in place before the intake is installed (see pics). The intake goes on and is held with a second set of flange nuts and torque separately. This is especially nice for aftermarket applications where the flange on your header may be a different thickness then the flange on your intake.
What do you guys think of these? Would you put them on your engine?
[img]https://photos.app.goo.gl/rub8vAYKD7iuvQPs8 [/img]
What do you guys think of these? Would you put them on your engine?
[img]https:/