Home built Paxton super charger setup possible for sale??? 194-292 - 09/17/07 02:22 AM
I am debating on selling my Paxton supercharger set up I made for my 250 Chevy.
I fabrcated the supercharger billet,brackets,pullies (three pullies IIRC)
I do not have a lot of time right now,to pull it out of a box & install it on a mock up engine, But I will get around to it & post some pics.
The Paxton is the SN 89,(the strongest case)w/a race compressor wheel.
Gearless planitary ball drive(very quiet!!)
It was rebuilt years ago,& I put maybe 50 Miles on it.Then put it away in a box.
It worked great!!
I ran mid 12's with this Paxton.
That was only 8-9 lbs of boost. You can get more if you use a smaller cam than I did.
My cam specs are 585 lift 236 248 @ .050. w/a 115 lobe center line.
The Blower unit cost me $1200. All the rest was fabricating,& materials.
I made it to use serpentine belts w/a spring loading belt tensioner.
If no body here is interested, I will put it on Ebay,,,,when I get the time to.
I am not in a big rush.....
Note::: I am not going to give it away,so dont try & offer very little for it.
There was a lot of thought & effort involved to get this setup made.
Just seeing if there is any serious interest in this.
Thanks!!!!!
MBHD
I fabrcated the supercharger billet,brackets,pullies (three pullies IIRC)
I do not have a lot of time right now,to pull it out of a box & install it on a mock up engine, But I will get around to it & post some pics.
The Paxton is the SN 89,(the strongest case)w/a race compressor wheel.
Gearless planitary ball drive(very quiet!!)
It was rebuilt years ago,& I put maybe 50 Miles on it.Then put it away in a box.
It worked great!!
I ran mid 12's with this Paxton.
That was only 8-9 lbs of boost. You can get more if you use a smaller cam than I did.
My cam specs are 585 lift 236 248 @ .050. w/a 115 lobe center line.
The Blower unit cost me $1200. All the rest was fabricating,& materials.
I made it to use serpentine belts w/a spring loading belt tensioner.
If no body here is interested, I will put it on Ebay,,,,when I get the time to.
I am not in a big rush.....
Note::: I am not going to give it away,so dont try & offer very little for it.
There was a lot of thought & effort involved to get this setup made.
Just seeing if there is any serious interest in this.
Thanks!!!!!
MBHD