I have a set of 6 Hudson connecting rods. They have a bushed wrist pin of .968 diameter, are 8.125 inches center to center, with a big end of 2 1/8 inch. $150.00.

Armond
Which motor are they from and do you have anything for a 308 you might want to part with? Have another Inliners member looking for parts. Thanks Rich,

These are all I have. I honestly don't know which engine they are out of. How do you tell the difference and I will check. PN casting?

IIRC all 232, 262, 308 rods are 8.125" long, 2.125" big end, but not sure if the same. The block and MB lengths match, so it's possible.

and they are all drop forged steel. I do know the engine they came out of had an approximate bore of 3.75 inch (with a ruler) but that's all of the information the fellow had. I'm guessing it was closer to 3.8 and it was a 308 but there is no way to know for sure without a casting number.

Thanks Armond

I have two sets of rods and pistons that were said to be 308 when I bought them on eBay. They measure out the same as above. One set of pistons measures 3.80" and is a long heave piston with 4 rings. One on the skirt. The rods have # 5303906 The other set has pistons that measure 3.85" and are lighter and shorter. They have 3 rings. The number on them is 303906 a diamond 24. They all have bearings in them that measure about 2.1".

5 of these rods are marked 303906 diamond 19 and one is just 303906. They all look identical. Thank you

Welcome! Hope they find a good home.

Me too!

SOLD