Inliners International
Posted By: cbmkr 292 Mexican block Project - 01/16/20 09:17 PM
Purchased this with a car i bought Never started
the Good Lots of new parts
14002009 L 20 8 Mexican Block over .060,New pistons 980P
New HO RV Camshaft 551M and Lifters and timing gear ( 12 bolt .com ),Crankshaft over .020 rods and mains ,New Clifford Valve cover and side covers, New HEI Dist New Oil Pump,New Offenhauser 4 bbl intake, New Cast iron Headers , 3895052 230 cyl head new valves and dual springs.
The bad Some idiot drilled a pin out of the rear of the crank thru the main cap into the thrust flange. Yes it can be fixed $200.00 line bore and $150 on thrust flange repair.
All the parts together i will not separate anything
$2000.00 Cash in hand when you pick it up.
Posted By: DoubleDingo Re: 292 Mexican block Project - 01/24/20 03:40 PM
Looks to be worked over, but wow that is pricey. Unless it was someone living in the same town, that engine would cost around $4k after driving there to get it. Yikes!
© Inliners International Bulletin Board