Does anybody have a manual transmission stock flywheel they may want to sell? I can have it machined. I just don't want one in too bad a shape. If it matters, my engine is from 1976.
PM, email through Profile , or post info here.
Thanks.
I have one but i am pretty far away i don't knownif shipping woul be worth it
Small block Chevy is the same unless yours has 1/2" bolts. You can have those drilled.
Small block Chevy is the same unless yours has 1/2" bolts. You can have those drilled.
I wondered that. Thought I had read it here before.
Josh, I'll keep you in mind.
Thanks to both of you.
Not the 400, they are externally balanced or the later one piece rear seal engines. Do you have the '76 bell housing? Does the starter bolt to it? If so you need a 168 tooth flywheel. There is another discussion on here about flywheels, starters and clutches.
Yes look in my posts i started the dicussion it really needs to go to tech tips a lot of hammering and fordging or ideas and knowledge in there seatch with quotes 'flywheel" in drivetrain catigorey! A lot about startes and such
Good luck stay inline
Seems I have more research to do. Thank you for the help.
Drew....I think I have what you need here in VA BCH. Clutch disc & pressure plate too. How soon do you need it? I think we'll be trippin' up past you there to the coast sometime in Sept. (We have an off-spring in Keansburg.)
Well, I was just informed that it will be a Thanksgiving trip, so that might not work for you.
Anyway, give me a call @ 757-636-9607. Not too early please as my wife is not well but I'm usually up @ the 'crack-of-noon'!
Back home. Will call later in this week. Thanks