Hi y'all inliners...
In Front cover of the Leo Santucci's Inline Six Power Manual Book, there's a photo from Mike Kirby's Altered T-23 Roadster 292 Drag Engine. Does anyone knows who's the Builder of that ENGINE HEADER ? Any info about that would be very appreciated.
Thank you,
MALDONADO

It's a Davis Step header. The decal is above the In memory of Kevin Kirby. I don't have a phone number or a email address.

Steven

Hello Mighty6...
Thank you very much for the info! No matter if you do not have the DAVIS' Telephone number or email address at this time, so I will try to get it immediately, but later if someone give you this info, just let me know . Keep in touch my buddy !
MALDONADO
Brasil - South America

hello....Mike told me they are stepped headers....1 7/8" to 2" to 2 1/8 "....the header i am making is using same step sizes- i am also using stainless steel Merge collectors .....going into a 3 1/4" collector-from a 2.5" "cone"/venturi.......I got the Merge collectors from a set of NASCAR V-6 headers....have fun......

Lee

I pulled this phone number from a performance directory: Davis Step Headers-(909) 391-2332

Hello...Old Newby,
Thanks very much for the info! Do you know if DAVIS has an email address or a WebSite ? Anyhow, your info was a great help for me.
Thank you,
MALDONADO
Brasil - S/A

I can't find one. Good Luck.

If you want to just write them a letter (I'm a cheap guy!) the address is

Davis Headers
135 S Oaks Ave
Ontario, CA 91762

I know they are very expensive, but are also considered one of the very best.

------------------
David

Hi...Just a Six (David)
Thanks very much for the info.I will write him a letter, so I did not find out any email address or a Web Page of Davis Step Headers, however I will be trying to get it.
MALDONADO
Brasil - S/A