Inliners International
Posted By: efi-diy billet bulkhead connector - 03/05/12 03:08 AM
[url=]30 pin firewall pass through[/url]

[url=]front view[/url]

Ever wanted to have a clean method to get wiring though a bulkhead (firewall).. and be able to disconnect the harness..

This is a 30 pin connector with 6 places for 10ga wires the rest are good for smaller loads or sensors.

The connector is watertight once the wire are inserted with the seal. The actual connector is made by Delphi - the billet block made here.
Posted By: Beater of the Pack Re: billet bulkhead connector - 03/05/12 04:30 PM
Damn, I may have to revise my NO BILLIT rule! \:D That is neat.
Posted By: efi-diy Re: billet bulkhead connector - 03/06/12 10:47 PM
If anyone is interested I could supply either just the block or a kit ready to go.
Posted By: Titen Re: billet bulkhead connector - 03/07/12 11:54 AM
Nice piece, however, this should be in the 'Swap Meet' forum.

Tim
Posted By: efi-diy Re: billet bulkhead connector - 03/08/12 02:48 AM
 Originally Posted By: Beater of the Pack
Damn, I may have to revise my NO BILLIT rule! \:D That is neat.


... camo it - flat black.....
Posted By: Nexxussian Re: billet bulkhead connector - 03/08/12 04:59 AM
What pins does it use (wether pack, wedge lock, ....)?
Posted By: efi-diy Re: billet bulkhead connector - 03/08/12 04:17 PM
delphi metric-pak 240&480
Posted By: Nexxussian Re: billet bulkhead connector - 03/09/12 02:37 AM
Thank you.
© Inliners International Bulletin Board