OK got a harness, tbi unit and computer and most of the sensors. Working on getting the unused wires out of the harness.

Question, what should I do with the knock sensor? The vehicle I got the harness out of had a knock sensor in it (I got the harness from a 1500 Suburban, which had a V8, but its the same harness thats used with the 4.3L TBI. In that busted jeep link he mentions splicing the knock sensor into pin c14 to eliminate the use of a knock sensor, not sure what wire he means, the one coming out of the computer to the esc module or the one coming out of the esc module to the knock sensor.

A guy on stovebolt also says that I can use a GM 250 knock sensor.

Im just trying to find out what I need to remove and what I need to keep and if I need to go back to the yard and grab a esc module.


Chris
1952 Chevy 3600 (3/4 ton) pickup w/54 235
Clifford Intake w/ holley 4bbl carb