So I finally got my mock up kit from Stainlessheaders INC. Basically what they do is send you a box with a bunch of PVC fittings, some trick universal bends, and some flanges with bungs welded in place. What you do is route the tubing and fittings the way you want, pin it all together so it stays rigid, and then send it back to them. At that point they make a special "one off" fixture just for your headers. Then they cut and fit and weld the stainless tubing together. Here is where I after 8 long hours in the shop. Still have 2 tubes yet to far.
Still not sure if I am going to run both tubes under the pan to the passenger side or keep one on the drivers side for the true dual exhaust look. I did however find a youtube video of a guy who ran his pipes seperate like I want and the damn truck sounds pretty good. He's using purple hornies for mufflers. and it looks like he ran his one pipe under the tranny to the other side, and then all the way out the back. Have a look!
http://www.youtube.com/watch?v=read2TJU5agHere's a couple of videos of how Stainless INC. makes the headers once they get your mock up kit. Pretty cool!
http://www.youtube.com/watch?v=9s1-AZcPWAAhttp://www.youtube.com/watch?v=Bc-KhMl-6ss
