Took my mock-up engine off of the eng stand & installed into my new cradle.







Engine did not fit in the cradle so I had to remove some material in a few places.

Here: two places, next to timing cover & next to alternator bracket

Here: next to timing cover
:

Other than those problems the eng cradle works good.

Now I can pull my engine, so I can modify my oil pan, it does not clear the rack & pinion steering set-up I installed.
Also need to clean up my engine compartment while the engine will be out.
Note: my oil pan is not stock.

MBHD

12 port SDS EFI