...Sometimes I think I spend too much time typing and not enough time thinking.
I just ordered another mother load of stuff, including the Fel-Pro performance gasket that I hummed about. Also grabbed the CompCams crank/cam gears, valve lapper, valve spring compressor, 11/32" valve umbrella seals, piston ring filer, piston ring compressor, digital caliper, base/dial combo, 11" timing wheel, front oil breather cap, rear oil breather/PCV, turbo oil supply/return lines, and the sealed power complete gasket set.
All that and I still need a new fuel line. I know the dual feed line I bought has a 3/8" hose fitting but I plan to swap that with a 3/8" NPT to -6AN fitting but I need one at the pump end. I can't remember what size fitting I'd need on the Delphi MF0051 mech pump. My question is, what fitting do I need to adapt the stock pump to AN? ?/? NPT to -6AN. I used the stock bent metal line when I installed the pump. I'm away from the pump for the holidays and would love to spend the time searching for a matching fuel line but can't confirm the size. Anyone know?
