I drilled mine about 4 inches back from the front of the pan in the middle vertically on my 292 can post a picture tomorrow mine is jic
A picture would be great. I've seen a few online but a lot of the inline threads have broken picture links.
I did what CNC recommended and had the rods reconditioned and bolts Swapped for ARP. The machine shop took it upon themselves to press fit my pistons to the rods. I still have the bag of Spirolox retainers. If I look at either end of of the wrist pins I can see the empty groove where the Spirolox would go. Should they have installed them as well? Is a press fit better than the Spirolox only setup? I didn't expect them to do that for me but it's welcomed if the result is better.
