Wow! Thanks everyone for the info.
I have picked up a Holley Dominator ECU, a throttle by wire throttle body from GM and three GM LS3 42lb injectors. I will put one injector at each port and fire each of them twice at the appropriate time as if there were six of them. There isn't room for two at each cylinder. I figure that with the limited RPM I will run that I can wire it so that the ECU thinks there are six injectors and I can adjust the amount of fuel needed for each cylinder.
I will also run individual ignition coils and will work in a cam position sensor so I can run a full sequential setup and not batch fire.
This weekend I will work on the location and angle for the injectors.
Thanks again everyone!
