Inliners International Forums General Discussion Drive Train hydraulic throwout bearing for 235/261 ??

Has anybody had any experience installing a hydraulic throwout bearing in a 235/261. Can it be done?

Ed

Dear Ed;

If you are speaking of a hydraulic clutch release system, yes.

The Chevy trucks used that for a while in the 60s. The fork was on the R/side with the 'slave cyl & the master had two parts (side by side).

This is what is used to put a stick in a 6 cyl Vette.

Ford did it too in late 50s.

John M....

Ed,

The hydraulic "puck" type T.O. should fit in any vehicle the manufacturer specifies, doesn't matter if it's V8 or a six. I wouldn't use one that is only held in place by the plumbing. I haven't installed one, just investigated it a bit.

Baldy