Inliners International Forums General Discussion Engines quick 194ci question

I have a 194ci engine out of a 1966 chevelle thats in my 1965 chevy II. I was looking a a 2 barrel manifold off of cliffords website. It said it was water heated. Now does that mean it won't work with my engine or what? Here it is http://cliffordperformanceshop.com/cata ...s_a_1824826.htm

Also will the weber 32/36 DGV 5A bolt right up with it? thanks - Chris

[This message has been edited by 65 chevy2 (edited 01-04-2004).]

[This message has been edited by 65 chevy2 (edited 01-04-2004).]

That intake will bolt up to you motor. And you can run water on that intake if you wish or need to do so. As for your carb/weber bolting to it That I'm not sure I don't know the webers all that well.(if they all have the same base bolt patteren) Call Tom Langdon Or cliffords and ask them.Hope this helps }[oooooo]



------------------
NovaMan/Twisted6/Larry

If i do get that manifold, would I HAVE to run water to the intake?

http://www.stoveboltengineco.com/acartpro/product.asp?productid=95
is that a holley carb? also is that one new for 65 bucks or rebuilt?

No You don't have to But. If you are in the cold weather area Yes you will need it no dout. There has been many debates on heating the intake. You can go and do a search on this matter.Then if you still have any Questions you can ask them.Hope this helps
}[oooooo]



------------------
NovaMan/Twisted6/Larry