Inliners International Forums General Discussion Engines chevy six rocker arms

Anyone running a 250/292 with a solid lifter cam? What are you using for rocker arms? Where did you get them? I'm planning on using 250/292 adjustable rocker arms & studs on a 300 I'm (slowly) building. Any suggestions?
Edwin

I was running cranes 1.7 and Now I'm running comps.1.73. Any speed shop Or Jegs, Summitt
Hope this helps }[oooooo]


------------------
NovaMan/Twisted6/Larry

You wouldn't happen to have the part number on hand would you? Thanks!
Edwin

Look in your P.A.w catalog,they have them.

You can get them from Jegs Paw or just about any Hp shop But I'll look mine up as soon as i can and I post them.}[oooooo]

I have another question for you guys. What kinda screw-in rocker arm studs are you using with your rocker arms? I managed to snag the chevy six power manual a while ago (I'm a ford guy, but I figure that any book on building an I6 is worth something) & am getting the impression that you're using BBC 3/8" studs. I don't know a whole lot about the BBC & am I reading it right that you can get 3/8" & 7/16" studs? Sorry about all of these questions, but I'd like this head to go together right, the first time (unlike some of the other things I've tryed ). Thanks.
Edwin

I'm running the 7/16 studs which are bb studs. the 3/8 will work fine If your not planning on a BIG high lift cam. hope this helps. }[oooooo]