Inliners International Forums General Discussion Bench racing Head work

Hi Guys,
I have a question. A couple of months ago there was a series of postings by a fellow who was offering to do some high perfofmance porting, etc., on cylinder heads. I have been unable to find any of his postings, and I would really like to get in touch with him. Can anyone out there help me by leading me to him? Thanks in advance. Chiefoldephart

He has removed all his own post. You may check the Classifieds.Or look on Ebay for him. But Best bet is to call Mike Kirby. If you are looking for the best bang for the buck. I just finished doing a flow test on one of his heads(Mike Kirbys with boss removed)- Before instaling a set of PES bolt in lump ports. (with 194 valves lift @ 600 and flowed 235 CFM) with the lump port And this was done on a Mike Kirbys Econo port(Street ported head) going for about 850-900 bucks Ready to bolt on without lump ports. Hope this helps }[oooooo]

------------------
NovaMan/Twisted6/Larry

[This message has been edited by Twisted6 (edited 10-29-2003).]