Inliners International Forums General Discussion Engines Offenhauser intake rings

Does the Offenhauser 2x1 intake have the ring cuts to help line up the manifold?

Yes.

Opps forgot to ask also if there is much trimming to do to get the Offenhauser 2x1 intake to fit up with the Fenton Cast Iron Exhaust on a 235ci.

Thanks
52pu

Yes, there will be some grinding needed to clear the rear fenton. You will need to mock everything up as you go.

Gearhead, I never did have to grind on the intake as you suggest although the rear manifold clamp sits at a different angle then the rest.I could snug it up tightly though. Is that the area you're referring to and will I need to grind it to prevent any damage?

Same setup on my 235 and no grinding involved, fits like it's supposed to. By the way, some of the Clifford intakes don't even have the rings, just a drilled flange, that the stud goes through, to line everything up.