A '54...
Any dual or single carb intake will fit...
BUT, not all will work with Fenton headers.
Some small amount if grinding on the bottom inside edge may be required when using an Offy intake, I have been told that the newer water heated Clifford 4bbl. intake will not work at all, but the earlier exhaust heated ones will. Tom Langdon may know more on this.
Keep in mind that any 37-62 intake COULD be used, but that the earlier engines had a slightly smaller intake port, so machining them out to the larger size would be needed. I don't remember off hand what the sizes were, I can look later if somebody else doesn't chime in.
Nearly all of the extinct brands of intakes were for the small ports, so take a tape measure with you. Even the Offy intakes are still being made for both port sizes, so watch out there too.
Most tripower intakes will require modifying the firewall and support rod...
