62-67 194-230 Pans Are center sump pick-up. Were as the 250 oil pans are Rear Sump pick-up.
And any Block that has a Rear sump pick-up Would need to be Drilled for the Dip stick Or the Tube would need to be welded to the Oil Pan. A piece or Round Bar/stock and a small hammer will make enough of a dimple in the pan where the drag link Just barely rubs the oil pan. I have done this On many and I have Never Rubed through a Oil pan yet. The drag Link Mainly touchs the oil pan at Max. Turning. I have been working on making some notched oil pans for the ChevyII body with 250s
( like the V8 pans) But have not had time to finish. and to make 100%sure everything clears.
If you need a picture of the area That needs to be addressed Just Email me and I'll send you it.
NEVER make Mods to the Drag Link Or Tie rods.
God doesn't like ugly.
