Originally posted by hecticblasts:
If everything else fails and you can weld or know someone who can, you could try welding the 4bbl opening from one base unto the original 6 cylinder base.It wont be 14" but it will retain the factory flavor.Good luck!
I fab'ed up my own from scratch........Sits over the valve cover like a stocker, but uses a SBC filter housing ass'y and moves the air through a piece of square tube to the carb.......I put curved pieces at the two corners to smooth the flow..........Best part is I can run the 14" filter, and once I finish the welds/pre/paint it, it will look stock.
