http://www.inliners.org/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=4;t=000192 Try this older thread.
The main part of the bracket is 1/4" thick and bolts to the two front bolts on the side if the head. A 1/8" x 1" bar extends back to the bottom bolt behind plug #2. A second 1/8" bar is welded to the top of the bracket. It goes above #1 plug and below #2 plug at a 45 degree and then welded to the lower bar. A 9/16 round bar is drilled and tapped on both ends and welded to the top of the bracket about even with the middle of the valve cover height. This is the inside pivot point for the pump.
The adjustable part of the bracket is part of the VW Jetta bracket, which is where the pump came from.
