I am trying to swap a six into my 68 GMC 4x4. The truck currently has a v8 in it, so I am a bit lost on the motor mounting of a six. I had originaly planned on a 250 motor, but had a 292 dropped in my lap so its going to be used. The only problem I see so far is the engine cradle in the truck would need to have one of the mounts moved forward a few inches. Soooo, is there a company that makes a bracket to move one of the 292 engine mounts rearward to match the trucks crossmember? If not what about a piece of steel plate bolted to the block and streching rearward so that the mount could be welded to it and bolted up? help.....
[This message has been edited by Rayzors68 (edited 10-31-2003).]
