If you have a press you can do the gear yourself.
Just be sure to heat before installing it. If you
don't heat You willend up shaving the inside
of the gear and then you will have a Lose fitting
Gear.It can be heated in a House hold over. It can also be heated in a Pan of boiling water/or oil. You can use a Old Temp (mech.) water gauge.
The Over will be much better and you will get a Much Higher tempature 450 degrees will work.Put the gear on a cookies sheet ALL being cold put it
in the over turn it on to 450 Once at 450 let it saty for about 5-10mins Then Install it on the cam.
It will never be a Drop fit But it will press on very easy With out shaving out the center of the gear. IF you can chil the cam Fine it not thats ok.
God doesn't like ugly.
