I need a little help troubleshooting here. When I turn my igniton to on, it blows the starter fuse. I have a painless wire harness with a push button start. Very, very simple system. I traced a direct short to ground all the way to the distributor, which is 4 months old and worked great before. I disconnect the distributor from the coil and the ground goes away. Took the cap off and pulled the points apart so they were not making contact and short goes away. The coil reads about 4.5 ohms between the + and - terminals. Checked another one I had sitting in the garage and it reads the same. Need more info I'll give it. Any ideas I'll try them.
