Originally posted by Twisted6 I.I #3220:
when you set the floats did you have the carbs sitting like they do on the intake? on that what looks like a slite angle? And just a 2cent note you may want to pull those end pins and install studs so you don't end up with a exhaust leak.
Thanks Larry, Actually I set the floats during the carb assembly/rebuild. According to the instructions, you need to measure them in relation to the surface of the inverted air horn. Also, you're absolutely right, I should have replaced the pins on the head with studs when I did all of the other ones. I realized that once I had already set the engine in. I'm pulling the head off in a couple of months and I'll do it then. Thanks for keeping me inline! (pardon the pun) :p -Tim "Doc"
