no there are a few that are the same dia. as the 292 and can Be drilled for the 1/2 bolts. It is to my understanding That there was some But Not very many.I found this out just as i was about to redrill one of my 250 cranks. I had already Redrilled the flywheel. And i did that under sized so that a file fit was needed to fit the bolt shoulder like a Pin fit TIGHT. as most flywheels the holes themself Could be much/alittle smaller. to hold the shoulder of most bolts Much Tighter This is one issue I have seen with the STD flywheels. This to me is a issue Because You have to much play around the bolts as I see it.So when i order my next flywheel I plan to have the holes Undersized So that i can make a tighter fit.around the shoulder of the 7/16 bolts on the low deck motors(194,230,250) To me the play is a issue with the harmonics from the start. I think this is one reason also that GM did the pins So that the flywheel couldn't walk from the get/go persay.
But anyway I was just woundering if you had seen one. no biggie and not like I'm going to go out of my way to find one either.So just thought i'd ask. thanks
}[oooooo]
God doesn't like ugly.
