ACTUNG! With a torque tube rear end you'll need to cut off the 'pivot' original attachment, or your rear end will flop over!. So after you cut the pivot ears off nice and neat just pick up a rear end mounting kit from any one of a zillion vendors or make your own. Either way you'll need to rotate the rear axle so it is at the same angle as your transmission.
The pinion shaft of the rear end should be same angle as output shaft of trans, or parallel to one another not one up and one angled down. When you locate the rear end on the springs you will have to adjust the mounting hole that indexes to the spring bolt so the axle will be centered in your fender opening. Piece of cake!
