Thanks for the help guys...problem corrected and flywheel is installed. i was doing a search on pressure plates to get proper specs for torquing the press plate bolts. Came across an old thread from 7/19/04 titled "New Clutch Not Disengaging".Was scanning thru it and one responder suggested that the clutch disc was installed backward. It reads,"The disc has to go in with the raised portion of hub facing AWAY from flywheel." Is this correct????????
I checked my Haynes manual, and the reference pic shows the opposite...raised portion of hub facing
toward flywheel. I don't want to get my new tranny in,just to end up pulling it again because of an error.Any help?
