Hi All, yesterday when I went to move my 47 Chrysler out of the garage, the clutch pedal stuck to the floor. I removed the floor plate, got the clutch free, and it was working once again. Tonight, the same thing happens. What is causing this. A little history, I have a slow antifreeze leak at the back of the engine, there was antifreeze and crud in the bell housing, the release bearing had greasy goop all over it. I have not had a chance to pull the trans and clutch to repair the leak and to clean up inside the bell housing. I did vacuum out the area, got as much crud as I could from the outside. But why would this cause my clutch to stick in the pedal down position. Any ideas what I need to do to correct all of this.........47 man
