I went to buy the parts for the PCV jar and only found about 1/8 diameter hollow all threaded pipe. 1/8 is the diameter of the hollow part. It's a pipe used for lamps, but that was the largest diameter they had. Do you think that will get the job done or do i need to look somewhere else for a larger diameter one? I looked at where the pcv hooks up to the manifold and the port on the intake looks about the same diameter as the threaded pipe i bought. Since the hose has to be the same d iameter on both ends im thinking this pipe will have to do. I got everything else and am ready to build it hopefully tomorrow. Do you think that pipe is wide enough cause i cant find anything else?
Is there a problem if the pipe going to the intake is only about 1/2 inch away from the one in the center?
