I have an 86 ford pickup that I have owned since new,I have chopped it and beefed up the motor some,it is a 300 six,head milled .030,ported and polished,crane cam,lifters,pushrods and valve springs,clifford headers,dual exhaust,clifford water heated manifold,650 edelbrock carb and accell coil. I have not had access to a dyno to test it yet so any guesses on how much horsepower it would have? Also I have purchased a plate nitrous system and will install it after I change the pistons and rods to forged type.Any tips on running nitrous?,what compression to run etc.The kit has 50,100,and 150 horsepower jets.I would like to go with the 150 of course,any thoughts??? :p
