Hello, been a little while since i posted here last, but looking for a little help.
Here's the run down... 54 with a 235, powerslide car, not running a 700R4, i've been plaged with problems with my 2x1 setup and pulled if and got my offy 3x1 on. Built a progressive linkage setup, and running the stock rochester B's...i beleive actually the BC's because of the chokes, the stock carbs for the car. with all 3 carbs on it's misfireing, took 2 carbs off and it runs very good, also found a bad accelorater pump on one carb. Is there anything that needs to be done to the outter carbs to make them more of dumpers? I set them up so the idle adj screws were backed out and richened up the center, same problem. Just looking for some advice or suggestions on getting it back on the road.
Thanks
