I've managed to get a set of 292 rods real cheap, and I have a set of N.O.S. jahns pop-ups for a 235. I am looking into making a small bore stroker engine, simliar to the Webrodder series.
what I was thinking of was bushing either the 292 rod small end to 0.866", or boring the piston pin to 0.927".
Which way is better?
This will be a street engine - probably driven hard at times - 1/4 and 1/8 mile runs occassionally, and the odd street race with a flathead or two
Thanks in advance for the advice.
