You guys crack me up!
You should know by now that I do things a little different than most. Yes, I bought the blowers so I could get accurate dimensions. "If I buy it, it may come" I will show a manifold that can place carbs or EFI in a downdraft version and also a Weber side draft version. The neat thing about a fabricated intake like this, I can make it with removeable top and side plate to cover all variations.
I wish this type of technology existed when I was a lad. Just think where it would be today!
Notice: I am not here to self promote myself for any type of monetary advancement, but I am a freelance Industrial Designer, who is doing a lot of side work for many Hotrod and Fab shops.
I am very passionate about this hobby and normally will work with any and all to get things done. If any of you would like to use my services, please contact me off line through my email. My goal is to eventually quit my 8-5 job and be a full time freelance designer in the Hotrod aftermarket. Sooner than later I'm hoping for this to happen.
Bob Malin
RapRap
1940 ChoppedChevyCoupe
