Don;
When I had to enlarge the hole in my bell housing to accept the T-5 I used a
magnetic based dial indicator. The magnet base attached to my flywheel with
the whisker of the dial reading the existing hole. I then rotated the
flywheel to locate the true center. What I found was the original hole was
about .012" out of position. I then had my machinist bore the new hole using
the true center I had established with the dial indicator. So I should be
dead nuts on. Better than factory. I also made a front bearing mount to
eliminate the pilot bushing and use a bearing in its place. Now that Pete
has shared the information on how to post pictures I will give it a shot.
Don Coatney
[img]http://photo.starblvd.net/DonCoatney/5-2-1-1066010878?m=1&pg=4&ro=1&co=0[/img]
[img]http://photo.starblvd.net/DonCoatney/5-2-4-1066366871?m=1&pg=4&ro=1&co=3[/img]
[img]http://photo.starblvd.net/DonCoatney/5-4-3-1065494592?m=1&pg=4&ro=3&co=2[/img]
[img]http://photo.starblvd.net/DonCoatney/2-1-1-1070670960?m=1&pg=1&ro=0&co=0[/img]
[This message has been edited by Don Coatney (edited 11-22-2003).]
[This message has been edited by Don Coatney (edited 11-22-2003).]
[This message has been edited by Don Coatney (edited 11-22-2003).]
