Ok, so I've had an Offy 3X1 Intake sitting for a while to go on my 58 235 in my 53 Chevy truck after messing with rebuilding rochesters and them still leaking I've decided I don't wanna go with them. I just talked to Tom Langdon and he recommended the
Carter/Weber two Barrel that he sells my understanding is that it's similar to the
Holley/Weber that he has that I've heard a few including my buddie 57Mike have used on their inlines with good results except this version is a little smaller so it should work better for my 3 carb setup.
So the question is what do you guys think? Am I crazy or will this work and run good on my fairly stock 58(car) 235. I do already have a split manifold and flowmasters installed, A PCV System, and a T5 Tranny and newer rearend.
Tom didn't seem to think I needed to change Cam's at this point he said I can if I want but that I would be trading the streetablity of the setup off. He estimated that these carbs move about 200CFM If you rate them like a 4 barrel (he said). Anybody know what model these are or has anyone used em?
Thanks,
MONGO
