Mongo,
Nice job, it sounds like you are experiancing the real power of an Inline in heat.
Your photos are not posting. Check on your posting.
As you might be aware, I also have a 3x2 set up but on a .040 over 292. I used the Holly/Webers from Tom and yes, he is the man when setting these things up. I have changed my jetting too. I have 51's in the primaries and 54's in the secondaries. It does idle high (900-1000) but I like it that way as I am rarely stopped! I used a Lokar Cable throttle cable which works fantastic. I did not have to modify my firewall as I have about 1/2" clearance with my Offy intake and Hellings air cleaners. Make sure the carbs are turned the right direction on the adapters. I believe Tom said to put the throttle controls at right angles to the valve cover and to the rear(facing firewall) This is done due to the proper float position. You'll experiment with the best throttle response, lag, performance and do some tinkering. I have electric chokes on mine and have them all hooked up. I did disconnect the rear choke arm as it was running way too rich on warm up.
Great job and keep it Inline!
