Everobody, thank you so much. This forum is the best with fast responses. I repaired the float by doing.
1. Created 2 holes on opposite sides of each other on the float using a small sewing needle.
2. This way I could blow out the fule inside and I then took water in my mouth to wash the remaining fuel out several times.
3. Let it dry for a while.
4. I found 4 smal 1/4" long cracks on the float which I used water sandpaper on to clean the surface.
5. I then used electronics soldering station together with plumbers tinn with 3% silver and soldering pasta too cover the small cracks and the two holes.
It seems to work. At least it took me to the
power hot rod reunion here in Sweden yesterday.
/Jonas
