That has been looked into, with a One on One with Edelbrock.So i will give you the short version. Bottom line was Yes there maybe?? a market BUT a very slim one at best,For the amount of time it would take to build the molds and tooling for said job
and the machine work there after. The costs would still be to high to just sit on the parts/Heads. And the time it would take to even sell off the First batch Still would not over come the
cost to make them for how little the Market of the older inline
engines.There is no remakes of the blocks What is still floating around at dealers OR GM. And you have to figure these motors are being SCRAPED out by most all Junk yeards by the tons. Because there is VERY FEW yards that even hold on to anything past the 90s. So where does that leave OUR little inlines?, in the melting pile.
God doesn't like ugly.
