I'm installing a Langdon's HEI (external coil) distributor on my 230 and I have questions about the wiring. The directions say to use a 10 guage wire for the positive power. Now my original dist. had the resistor wire going to a terminal on the starter and then a wire going to the key switch. Do I also need to run a 10 ga. wire from the starter to the switch?
My other question had to do with the plug going from the dist. to the coil. The red wire goes on the side of the coil with the spacer between the terminals-is that correct? Then I'm assuming I connect keyed 12v to the red using a spade terminal? If this doesn't make sense I can probably post some pics. Thanks.
