What year engine is the 250?
 Originally Posted By: Super250

1) What should I do to the engine to make it stand up to 10psi of boost?
Forged pistons
2) should I lump port it?
Yes.
3) What size of carb?
650 or there abouts.

4) are there cams for this specific application? or is there one that will work that is readily available?
You can have Comp Cams grind a cam for forced induction application.
I used a wide lobe center of 115 on mine.
5) should I plane the head at all to boost compression?
You do not need anymore compression for a blower

6) and what are you gernal suggestions as I am the young guy, new on the block, and eager to learn from the people that are wiser than me,

Found this camshaft

http://schneidercams.com/295HchevyI6hydraulic.aspx

Cam is a bit big on the duration side for only wanting to go 10 lbs of boost,plus lobe center is too tight/close.
What HP are you looking to achieve?
Really need more info to answer correctly,so those are just somewhat of general answers.MBHD

I appreciate your replies and feed back

12 port SDS EFI