Finally got around to looking at this.
The oil feed tube in the middle of the rocker assembly goes to what the manual calls the "oil connector". Only mine doesn't look like the picture in the manual. In the manual it has two tubes on the connector. Mine has one. It looks like someone welded up another hole on the connector where another tube would go. But, there's no place on the head for another tube to connect.
The good news, maybe: Oil was spraying out around the weld quite a bit. So, we're going to fix the weld and seal that up. I have a nagging worry about the other tube, but since there's no place for it to connect to the head will assume it will be OK.
Any thoughts before I ruin something?
