I'm listening to what Tom and Larry are saying. But I'm in a quandry. On the one hand, I don't like the thought of starting all over again building a new engine. It's time consuming and expensive. Just finding another good short block is tough up here.
On the other hand a rebore would be much simpler. Is it just a matter of a better cooling system?
I have a three core rad and dual fans now and have never had an overheating problem.
How about honing the cylinders to clear up most of the scuffing without a rebore?
I am really not sure which way to go on this. I am relying on your advice to make a final decision.
Al
