New member here, Mike from Rock Island IL USA. I've been reading here for a while and this thread got me to register. Haven't joined yet but I will.
I'll buy a set of these pistons if it becomes reality. Suggestions: Specify the compression height at 0 or .010 below stock deck height instead of the common .030 or more in the hole for stock replacement pistons. I would prefer blank tops for the most flexibility, also thick enough that a shallow dish could be machined in for those running boost. I also think that if going to the trouble of a special run, why not do it with a forging instead of cast? JE can make whatever you want for around $600. My guess is a larger quantity might drop that to $400 range which probably isn't much different than what a special run of cast pistons might cost.
