I have seen discussions on high output injectors and idle quality. this is a hotrod engine with a solid lifter Isky, assuming the .050 numbers are in the 230 degrees or so it's not going to idle like a stocker anyway(as said, not sure of actual specs but will pull cam to spec it). I just wonder if a ,say a pair of 120# injectors will idle OK. Trick Flow has these and should support more than enough for my initial plans and are affordable:
High performance fuel injectors from Trick Flow®.
Fuel Injector, TFX™, 120 lbs./hr., 4\1A Peak and Hold Circuit Driver, Each
Features:
Driver Type 4\1A peak and hold
Fuel Rail O-Ring Outside Diameter (in) 0.590 in.
Injector Advertised Flow Rate (lbs/hr) 120 lbs./hr.
Injector Impedance 2.2 ohms
Injector Plug Style Bosch/Amp-style
Manifold O-Ring Outside Diameter (in) 0.590 in.
O-Rings Included Yes
Outside Diameter (in) 0.971 in.
Overall Height (in) 2.830 in.
Quantity Sold individually.
Seat to Seat Height (in) 2.153 in.
Wiring Harness Included No
