logo
12 Port News - Features
12 Port History
Casting Numbers
Online Store
Tech Tips
Become a Member
Previous Thread
Next Thread
Print Thread
Rate Thread
#56326 03/21/10 08:31 PM
Joined: Nov 2009
Posts: 49
C
Active BB Member
OP Offline
Active BB Member
C
Joined: Nov 2009
Posts: 49
i just got my ignition figured out and i went to start my car and it will run for a secong or so when i stop cranking but when it is running it is spitting fuel out of the top of the carb it almost looks like it is comming out of the two little vents on top. But the carb is a brand new edelbrock 600 and i am running a holley blue fuel pump. when the motor does run the fuel press is at 3.5 - 4 psi i need help thanks

Joined: Apr 2004
Posts: 3,595
Likes: 42
1000 Post Club
****
Offline
1000 Post Club
****
Joined: Apr 2004
Posts: 3,595
Likes: 42
Are you sure the timing is set correct? Sounds like it may be off 180 degrees. Tom


Inliner Member 1716
65 Chevelle Wagon and 41 Hudson Pickup
Information and parts www.12bolt.com

Joined: May 2000
Posts: 1,464
1000 Post Club
*****
Offline
1000 Post Club
*****
Joined: May 2000
Posts: 1,464
It sounds like there is a bit of dirt in your inlet needle / seat assembly. Clean and blow out with compressed air - it should be OK.


FORD 300 inline six - THE BEST KEPT SECRET IN DRAG RACING!
Joined: Nov 2009
Posts: 49
C
Active BB Member
OP Offline
Active BB Member
C
Joined: Nov 2009
Posts: 49
fixed it!! fuel pressure reg went bad evry once in a while it would let full presure thru 15psi. new reg no problem now thanks!


Moderated by  stock49, Twisted6, will6er 

Link Copied to Clipboard
Who's Online Now
1 members (stock49), 6,104 guests, and 89 robots.
Key: Admin, Global Mod, Mod
Newest Members
Squid76, Sam Matthews, Howard5507, jrdunn, skibs3
6,921 Registered Users
Sponsored Advertisement
Sponsored Advertisement
This Space is Available
Powered by UBB.threads™ PHP Forum Software 7.7.5