bore is .020 over(3.801), no water modifications that i know of, he was running a electric pump to some sort of wasted setup, no mech water pump, just flowing cold water through from a tank to a reservior catch. I agree and will look at teh deck. I think i might get it surfaced and threads countersunk to be sure while its on the bench. he did have the rear head port hooked up to the thermostat housing which should be good for helping the rear cyls stay cooler.
I meant .295 lift on the cam...my mistake. The only reason I have to believe it is an Isky is teh previous onwer swore by it, I will pull the cover maybe tomorrow and see if i can see some markings then degree teh cam to get some accurate numbers. I know it's oldschool, but thinking of a 650 holley draw through for now, maybe Megasquirt later. It has a McGurk 5 carb intake on it now, so its either make a bolt on plate/plenum to mount the blower to that or for teh same amount of work just make a new intake. there would be an adapter fabbed to mount the carb to the blower as it is rear inlet.
Last edited by huffin53; 06/15/10 08:55 PM.
