Hi Guys!
1st Post after lots of reading..Good stuff!
Anyhow, I have a 57'GMC truck 3/4 ton with a stock 270 in it. The engine area is where my knowledge is weak and its time to get into it
Here is what I know (please correct if wrong)
-270s are moderately rare, and I would like to keep it rather than dropping a V into it
-302s and 270s have some interchangeable parts (have basic interchange manual)
So here are my plans:
-I've found, through here, where I can get a 2-up intake or a single 4 barrel (Preference for 1 v 2?)
-2pc exhaust manifold (Never have seen single like stock)
But here are my problems
-Would like to put an IFS in..hence need a new oil pan for 270 along with a rear oil pickup. Know where I can get one at?
-Motor Mounts?...Have seen Classic Pickup do a very 1-off v-type engine mounts for a 6...anyone have experience or suggestions they can shed? Basically 1st step in the IFS install is to cut off the old cross member and throw it out.
Any help or guidance would be greatly appreciated. I'm really trying to go the distance to keep the I6 rather than a junky V.
Thanks!
Ben
